Ritetemp 8050C User Manual

1-405-061Made in ChinaInstall guide 8050CCustomer Support: 888-515-2585 or Visit our website www.ritetemp-thermostats.comHEAT COOLAUTO

8050C FeaturesPG 17PG 18STEP 1 - Connect the G wire to the G terminal on the thermostat. This connects the Fan.STEP 2 - Add a jumper wire between W an

Install guide 8050C1 LocationCautionTools To avoid electrical shock and to prevent damage to the furnace, air conditioner, and thermostat, disconnect

3 Remove old unit2 Label Wires from Old Unit4 Mount the 8050C.Separate front from back of unit. Press up on thecatch on the bottom of the thermostat a

PG 57 Install BatteriesThe 8050C requires batteries to operate your system and retain its programming in memory. .Switch MODE switch to OFF and the FA

PG 8PG 7Please refer back to these guidelines for safe and secure wire connections..Take care not to damage the labels for each wire in handling..Stri

PG 10PG 9RHGYWCFrom FurnaceAnd AC unitRorRCGYWCFrom FurnaceAnd AC unitRHGo To Page 13Go To Page 14Go To Page 12RHWCFrom FurnaceGGo To Page 17Go To Pag

PG 11PG 12 Go To Page 10STEP 1 - Connect the R (or RH) wire to the RH terminal on the thermostat. This connects to the Heater Power.STEP 2 - Conn

PG 14PG 13RGYWCRHorFrom Furnaceand AC unitSTEP 1 - Connect the Y wire to the Y terminal on the thermostat. This connects to the Cooler compressor.STEP

PG 16PG 15Go To Page 10Go To Page 10NOTE: Wires marked with the dotted line are optional.STEP 1 - Connect the G wire to the G terminal on the thermost